Option 3: Floor Drain; Connecting To The Power Supply - Kenmore 796.4116 Series Use & Care Manual

Table of Contents

Advertisement

Available languages

Available languages

CONNECTING
THE DRAIN
HOSE
• The drain hose should always be properly
secured.
Failure to properly secure the drain hose can result in
flooding
and property damage.
• Do not install the end of the drain hose lower than 29
in. (73.7 cm) or higher than 96 in. (243.8 cm) above the
bottom of the washer.
• The drain must be installed
in accordance
with any
applicable
local codes and regulations.
• Make sure that the drain hose is not stretched,
pinched,
crushed, or kinked.
NOTE:
A drain hose extension kit is
available if the drain hose is not
long enough. Do not extend the
drain hose more than 6 feet, as
this will cause poor draining,
which will result in poor wash
and spin performance.
I
Drain Hose Extension
P/N 5215ER20021<
Option 1: Standpipe
f
Hose
Brooke
Strop
J
Install the end of the drain hose into the elbow bracket.
Do not extend the drain hose more than 4 inches past the
end of the elbow bracket. Use a tie strap to secure the
drain hose in place.
NOTE:
• Total height of the hose end should not exceed 96 in.
(243.8 cm) from the bottom
of the washer.
• The drain hose should be inserted no more than 8-12
inches into the standpipe.
Inserting the hose more than
8-12 inches can cause mold or microorganisms
to
spread to the inside of the washer.
If the water valves and drain are
built into the wall, fasten the drain
hose to one of the water hoses with
the tie strap (ribbed side on inside).
Tie Strap
Option
2: Laundry
Tub
Utility
Sink
The elbow bracket should be installed
near the end of
the drain hose. Hang the end of the drain hose over the
side of the utility sink. Use a tie strap to secure the drain
hose in place.
Option 3: Floor Drain
f
Drain
Hose
\
Floor Drain
J
Insert the end of the drain hose into the floor drain.
If possible, secure the hose to prevent it from moving or
coming out of the drain.
CONNECTING
TO THE POWER SUPPLY
The washer should be plugged into a 120-VAC, 60-Hz
grounded 3-prong outlet. Plug in the washer.
J
10

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents