Assembly - Power Wheels xtreme machine 74790 Owner's Manual

F
1
Knob
Vehicle
Body
• Position the vehicle body on a flat surface.
• Snap the key assembly and knobs into the vehicle body.
2
Left Fender
• Using safety scissors, separate the right and left fen-
ders from the plastic connector. Dispose of the plastic
connector.
• Fit the tabs on the rear fenders into the fender slots in
the right and left sides of the vehicle body.
Please Note: The right and left fenders are NOT
interchangeable.
• Set the vehicle body aside.
Do not omit any steps. Please set aside at least
90 minutes for assembly.
Key

Assembly

Knob
Right Fender
Assembly
3
Door
• Using safety scissors, separate the door and handle from
the plastic connector. Dispose of the plastic connector.
• Fit the roll cage door handle onto the roll cage door.
• Insert three #8 x
the door.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
4
• Position the left roll cage with the connector post facing
up.
• Fit the bottom of the roll cage door against the cross
support on the left side of the roll cage.
10
3
/ " screws through the handle and into
4
Door
Assembly
Left Roll
Cage
Cross Support
Handle
Connector
Post