PILOTAGE Stinger 3D 250 User Manual page 9

Tx Battery Installation
Ensure that the On/Off switch is in the "Off" position. Remove the battery cover by pressing down on the hatch and moving the
hatch away from the casing. Remove the battery cassette from the Tx.
Install 8pcs AA batteries into the battery cassette as illustrated. Please note the polarity markings (+ and -), and follow them
when installing the batteries. Please ensure that you install fresh batteries. Do not mix old and new batteries. Batteries may leak if
attention is not paid to these precautions.
When placing the cassette back into the Tx casing, do not force the battery output lead into the socket. It will only fit in one
direction. If it does not slide into the socket easily, check that the lead is correctly positioned and try again. If the lead is installed
incorrectly you risk reversing the polarity of the connection which may damage your Tx or cause a fire hazard.
Once the batteries have been properly installed close the battery hatch, and set aside the Tx for later use.
8