PILOTAGE Stinger 3D 250 User Manual page 13

5. Receiver connection layout
Receiver
Antenna
ELEV
This slot is used for the pitch/elevator servo (the servo in front of the swashplate)
AILE
This slot is used for the roll/aileron aervo (the servo to the left of the swashplate if viewing the model from tail to front.
THRO
This connects to the BEC output from the ESC to the receiver
RUDD
This slot is used to connect to the gyro (the servo connected to the gyro and the gyro connects to the Rx)
GEAR
Not used
AUX1
Connects to the pitch servo (this servo is to the right of the swashplate if viewing the model from the tail to the front)
AUX2
Connects to the gyro sensitivity lead
BATT
Not used
12
ELEV – Pitch/Elevator
AILE – Roll Servo/Aileron
THRO - Throttle
RUDD – Yaw/Rudder
GEAR – Extra Channel
AUX1 –Pitch
AUX2 – Gyro Sensitivity
BATT – Battery