Nostalgia Electrics MDF200 Instructions And Recipes Manual page 12

11. Reassemble your AUTOMATIC MINI DONUT FACTORY™ .
By following these simple instructions, your AUTOMATIC
MINI DONUT FACTORY™ will be a fun and special treat
for your family, friends and kids of all ages!
To prolong the life of your AUTOMATIC MINI DONUT FACTORY™ , be sure
to follow the cleaning instructions above after each and every use.
BREAKDOWN OF DOUGH DISPENSER FOR CLEANING:
1. Put your finger on the plunger as you turn the donut hopper over. You should
notice the Dough Release is extended. Unscrew this part. See illustration below.
2. Using your thumb and first finger, firmly pull up on
one end of the 'wings', releasing it from the outer
edge. Now, release the second 'wing' the same way.
3. Now you can remove the plunger and stem assembly.
4. Turn the Dough Dispenser over and press in to
release inside peice from inside mixer.
5. You should now have all four parts to the Dough Dispenser released
for cleaning. Wash in warm, soapy water. You may need to push the
plunger down exposing the lower threaded stem and confirm that
the stem portion above the threads is clean and smooth.
6. Reassemble after cleaning and drying.
NOTE: You may find it
necessary to use a small,
fine brush to clean the
hardened and caked
donut batter from cracks,
crevices and the spring
on the trigger stem.
Dough Release
Wing
Plunger
Outer Edge
10