Manually Pairing Wireless Subwoofer - LG SH4 Owner's Manual

14 Connecting

Manually pairing wireless subwoofer

When your connection is not completed, you can
check red LED or blinking green LED on the wireless
subwoofer and the wireless subwoofer does not
make sound. To solve the problem, follow the steps
below.
1. Adjust volume level of the main unit to minimum
by pressing VOL p button repeatedly until
standby LED (Red) turns on for 2 seconds and
2
blinks slowly.
2. Press and hold
for about 3 seconds.
- The standby LED (Red) on the main unit blinks
quickly.
3. Press and hold Pairing on the back of the wireless
subwoofer for more than 5 seconds.
- The LED of the wireless subwoofer lights up
alternately in red and green.
4. Disconnect and reconnect power cord of the main
unit and the wireless subwoofer.
(Mute) on the remote control
5. Turn on the main unit. : The sound bar and
wireless subwoofer will be automatically
connected.
- Green LED on the rear of wireless subwoofer
turns on.
,
Note
y It takes a few seconds (and may take longer)
for the main unit and the subwoofer to
communicate with each other and make
sounds.
y The closer the main unit and the subwoofer,
the better sound quality. It is recommended
to install the main unit and the subwoofer as
close as possible and avoid the cases below.
- There is a obstacle between the main unit
and the subwoofer.
- There is a device using same frequency
with this wireless connection such as
a medical equipment, a microwave or a
wireless LAN device.