Product Specification; Operating Controls; Intended Use; For Your Safety - Bosch ASM 32 Operating Instructions Manual

Product Specification

Cylinder Mower
Part number (typ)
Rated power
Blade width
Height of cut
Grassbox capacity 31 l
Weight
Protection class
Serial Number

Intended Use

This product is intended for domestic lawn mowing.
Introduction
This manual gives instructions on the correct as-
sembly and safe use of your machine. It is important
that you read these instructions carefully.
When fully assembled the machine weighs approxi-
mately between 8.5 and 11 kg. If necessary, obtain
assistance to remove from packaging.
Take care when carrying the mower to the lawn, as
the blades are sharp.
Delivered Items
Carefully remove the machine from its packaging
and check that you have all the following items:
– Lawnmower with handle assembly
– Handle bottom
– 2 bolts (fitted to handle bottom)
– 2 wing nuts (fitted to handle bottom)
– 2 pivot pins (fitted to handle bottom)
– 2 pivot covers (fitted to handle bottom)
– 2 Grassbox parts ASM 32
– Grassbox ASM 32 F
– Operating instructions
When parts are missing or damaged, please contact your
dealer.
12 • F016 L70 453 • 06.11
ASM 32 ASM 32 F
3 600 H89 A.. 3 600 H89 B..
360 W 340 W
32 cm 32 cm
12 – 32 mm 12 – 32 mm
23 l
11 kg 8.5 kg
/ II / II
See serial No 10
(rating plate) on machine.

Operating Controls

1 Handle top
2 Switch lever
3 Securing knob
4 Mains plug**
5 Cable restraint
6 Handle bottom
7 Grassbox
8 Height of cut lever
9 Ventilation slots
10 Serial Number
**Country specific
Not all of the accessories illustrated or described are
included as standard delivery.
Warning! Switch off, remove plug from mains
before adjusting, cleaning or if cable is cut,
damaged or entangled.
The blades continue to rotate for a few sec-
onds after the machine is switched off.
Caution – do not touch rotating blades.
Electrical Safety
Your machine is double insulated for safety and re-
quires no earth connection. The operating voltage is
230 V AC, 50 Hz (for non-EU countries 220 V,
240 V as applicable). Only use approved extension
cables. Contact your Bosch Service Center for de-
tails.
Extension cords/leads should only be used if they
comply with H05VV-F, H05RN-F types or IEC type
design (60227 IEC 53, 60245 IEC 57).
If you want to use an extension cable when operat-
ing your product, only the following cable dimen-
sions should be used:
2
– 1.0 mm : max length 40 m
2
– 1.5 mm : max length 60 m
2
– 2.5 mm : max length 100 m
It is recommended for increased electrical safety to
use a Residual Current Device (RCD) with a tripping
current of not more than 30 mA. Always check your
RCD every time you use it.
If the supply cord is damaged, it must be replaced by
a Bosch Service Centre.
English - 2

For Your Safety