Download Print this page

Tannoy CMS 403DCe Quick Start Manual page 4

Hide thumbs Also See for CMS 403DCe:

Advertisement

7 Wiring and Setting Up
1. Open the wiring cover (if applicable) and locate
the Euro-type connector plug and socket at the
back of the speaker. (Fig.1)
2. For connection to an amplifier, use Pins 1 and 2
(Fig.2)
• Pin 1 is positive
• Pin 2 is negative
For connection to
additional speakers
in a distributed line,
Pins 3 and 4 are in
parallel where:
• Pin 3 is negative
• Pin 4 is positive
3. Close the wiring cover and tighten both screws
on the cable clamp (if applicable).
4. Use the rotary switch on the front of the unit
to select low impedance (LoZ) mode or high
impedance (70 V or 100 V) for distributed
applications.
The speaker is supplied in low impedance
mode, Never connect the speaker to a
70 / 100 volt amplifier while it is set for
low impedance.
Tannoy operates a policy of continuous research and development. The introduction of new materials or
manufacturing methods will always equal or exceed the published specifications. All specifications are
subject to change without notice. Copyright (c) 2014 Tannoy Limited. All rights reserved.
CMS 403DCe and CMS 503DC models (all
variants) use a 30 W transformer. In distributed
line applications, the transformer can be tapped
at 30 W, 15 W and 7.5 W, with an additional
3.75 W tap for 70 V line systems.
CMS 603DC and CMS 803DC models (all
variants) use a 60 W transformer. In distributed
line applications, the transformer can be tapped
at 60 W, 30 W and 15 W with an additional
7.5 W tap for 70 V line systems.
8 CMS Series BM Dimensions
Fig.1
Please refer to the full CMS Series Operation
Manual for dimensional drawings.
CMS 403DCe
Hole cut-out: 187 mm Diameter
Height
CMS 503DC BM
Hole cut-out: 190 mm Diameter
Height
CMS 603DC BM
Hole cut-out: 253 mm Diameter
Fig.2
Height
CMS 803DC BM and CMS 803DC Q
Hole cut-out: 295 mm Diameter
Height
Maximum, including bezel ring
1
Maximum to top of connector, from lower
2
ceiling surface
tannoypro.com
: 147.6 mm (5.81")
2
: 205.3 mm (8.08")
2
: 273.3 mm (10.76")
2
:327.7 mm (12.9")
2
: 205 mm (8.07")
1
: 205.9 mm (8.11")
1
: 274 mm (10.79")
1
: 319.0 mm (12.56")
1

Advertisement

loading

This manual is also suitable for:

Cms 503dc bmCms 603dc bmCms 803dc bm