Cisco CPA2501 User Manual page 98

Closing the Chassis
Caution
end and then the other, working back and forth; however, use care to prevent bending the
chassis edges.
Figure B-8
Rear
Step 3
Step 4
Step 5
Step 6
B-14 Router Installation and Configuration Guide
To fit the two sections together, it may be necessary to work them together at one
Replacing the Chassis Cover
A
Top section
Bottom section
Left end
toward you
When the two sections fit together snugly, turn the chassis so that the bottom is
facing up, with the front panel toward you.
Replace the cover screw. (See Figure B-1.) Tighten the screw to no more than
8 or 9 inch/pounds of torque.
Reinstall the chassis on the wall, rack, desktop, or table.
Replace all cables.
C
B
Front