Whirlpool THIN TWIN Installation Instructions Manual page 5

Before you're ready to attach
water supply hoses, run a
little woter from the faucets.
This gets rid of any particles
that might clog the hoses. Use
the new hoses and flat washers
that come with your WhIrlpool
washer/dryer
Now place a flat washer into
each end of the Inlet hoses.
(Check to make sure washers are
firmlv seated in couplinos.1
Attach hoses to faucets~~ghten
couplings by hand. then make a
final two-thirds turn with pliers.
19
n
Washer fill hoses, drain hose and
electrical cord can be connected
before movrng the washeridrver
into final position if work space
cermlts. For installoticn in recessed,
closet of mobile home locations
see Alternate Installations. Panel F)
A?ach the hose from the cold
water faucet to the top valve
opening [marked "C") on the
wcsher Next attach hot water
hose to the opening (marked "H")
underneath Ttghten couplings by
bond. then make an additional
two-thrrds turn with pliers
/
EC----- /
/
Put the "hook"
drcin hose In the laundry tub or
standplpe. Estimate how far
awav the machtne WIII be when
It is in Its permanent place. Cut
the flextble end of the hose to
that lenath. IDo not cut the hcok-
shcoegend 1
Push adapter or flexible end
of hose. Slide large clamp over
adapter and hose.
k
Remove cap from connector
then put the small clamp on the
,\
conn&or.Push the hose adapter
on the connector Usino pliers
open clamp and slid;& clamp
over the adapter. Release clamp
and check for secure fit. ,
PANEL D