Whirlpool THIN TWIN Installation Instructions Manual page 3

Now start.. .
1.
Using a %h Inch socket wrench
remove the two bolts holdina the
wood pallet to the botlom oithe
washer/dryer
Then remove the pallet. Remove
011 parts from the plastic package
Line these up next to yovrtools
so each part IS there when you
need It
Check to see that you have these
e 4 legs
l
1 hose adapter
l
2 hose
dorms l
taae
l
4 flat water hose washers
3 8
Pick up o rear leveling leg: turn
It so the flat side and pegs fit Into
the hole in the reorcotner Push
the leg In until it snaps into place.
Do the same thing with the other
leveling leg in the other rear comer
I. ,
4
n
When you have both rear legs in.
push up on one leg: check to see
if the other leg goes down. Check
the other leg in the same way.
(If the legs don't adjust as they're
moved. go through step 3 again.1
Start to screw the front legs into
the hole by hand. A little liquid
detergent to
lubrkde
the screw
will help. (Youll need pliers to turn
the leg all the way to the diamond.!
5.
With one of the front legs in hand,
check the ridges fw a diamond
markq. That's how far the leg is
supposed to go into the hole
in the triangular brace at the front
comer of the machine.
Using a Yz" wrench. remove the
two ShIppIng bolts. The shipping
bolts are the largest belts. Da not
remove the three smaller bolts
OS they am part of the suspension
system.
PANEL B