Jocel JPK4GI200136 Instruction Manual page 58

Replacement of the oven light bulb
WARNING!
In order to avoid the possibility of an electric shock ensure that the appliance is
disconnected from the power supply before replacing the bulb.
Set all control knobs to the position"●"/"0" and

disconnect the mains plug
 Unscrew and wash the lamp cover and then
wipe it dry.
 Unscrew the light bulb from the socket, replace
the bulb with a new one-a high temperature
bulb (300℃) with the following parameters:
-voltage230 V
-power 25 W
-thread E14.

Screw the bulb in, making sure it is properly
inserted into the ceramic socket.

Screw in the lamp cover.
Door removal
In order to obtain easier access to the oven chamber
for cleaning, it is possible to remove the door. To do
this, tilt the safety catch part of the hinge upwards.
Close the door lightly, lift and pull it out towards you.
In order to fit the door back on to the cooker, do the
inverse. When fitting, ensure that the notch of the
hinge is correctly placed on the protrusion of the
hinge holder. After the door is fitted to the oven, the
safety catch should be carefully lowered down again.
If the safety catch is not set it may cause damage to
the hinge when closing the door.
Removal of the internal glass panel
Unscrew and unfasten the plastic latch that is in the
corner at the top of the door.
Next take out the glass from the second blocking
mechanism and remove.
After cleaning, insert and block the glass panel, and
screw in the blocking mechanism.
,
57