Nikon LS-2000 User Manual page 8

When transporting the scanner
The LS-2000 is for use only in the country of sale. Nikon will not
be held responsible for consequences resulting from use overseas.
The scanning mechanism must be locked in its home position for
transport within the country. To return the scanning mechanism to
its home position, remove any adapters from the adapter slot and
then turn the scanner on. The status LED will blink while the
scanning mechanism returns to the home position. Wait until the
status LED glows steadily, then turn off and unplug the scanner.
Place the guard in the adapter slot as shown below, sliding it in until
it contacts the back of the slot.
Remove the transport locking screws from the rear panel and screw
them into the holes provided in the side panel and the mouth of the
adapter slot (the hole in the mouth of the slot should align with the
hole in the guard). Close the front cover and pack the scanner and
adapters in the original packing material for transport.
Caution: Do not transport the scanner without first locking the
scanning mechanism with the transport lock screws. Moving the
scanner without the lock screws in place could damage the mecha-
nism.
vi Nikon
LS-2000 35 mm Film Scanner User's Guide