Nikon LS-2000 User Manual page 22

3. Setup
When the scanner is between other devices
1. Set the terminator switch on the rear of the scanner to OFF
2. Connect the SCSI cable from one of the devices in the chain to
3. Confirm that the last device in the chain is terminated
Note: If the last device in the chain has an unused SCSI connector,
a separate terminator should be attached to it, even if the device is
connected to the SCSI chain using a through terminator.
12
either of the connectors on the rear of the scanner, then connect
a cable to the remaining connector and attach the other end to a
connector on the next device in the chain
Nikon
LS-2000 35 mm Film Scanner User's Guide
TERMINATOR
OFF
100–240V~
0.3–0.2A
50/60 Hz
1 0 0 0 9 8
MADE IN JAPAN
SCSI NB
TERMINATOR
4
OFF ON
0
S C S I S C S I
ON
Other SCSI device
Terminator