Power Supply - Sanyo CDP-4000 Instruction Manual

POWER SUPPLY
AC adaptor
Plug one end of the AC adaptor into the
DC 6V socket, then plug the other end
into an AC outlet.
- Use only the supplied AC adaptor
If the AC adaptor is connected. The
power supply automatically switches
to the AC power source and the
installed batteries are disconnected.
Rechargeable battery
1.
Install the rechargeable nickel-cad-
mium battety (SANYO NBP-30B) as
shown below. Observe proper polar-
itv.
2. Connect the AC adaptor. The bat-
tery is fully charged approximately
10 hours after the AC adaptor is
connected.
Do not charge continuously for 24
hours or more.
CONTAIN NICKEL-CADMIUM
BATTERY. MUST BE RECYCLED OR
DISPOSED OR DISPOSED OF
PROPERLY.
Alkaline batteries
Install two "AA" batteries (not supplied)
as shown below. Observe proper polar-
ity.
Battey recharging or replacement
If the rechargeable battery or alkaline
batteries are weak and discharged,
"~" blinks on the display, then the
power automatically turns off. If this oc-
curs, recharge the rechargeable battety
or replace the alkaline batteries.
Dispose of all used batteries safety
and in accordance with all appli-
cable laws.
Note:
When you are not going to use the unit
for one month or more, take the batteries
out of the battery compartment.
5