Trimming New Growth - Black & Decker HH2455 Instruction Manual

Figure
F depicts the rear handle in 90 ° left (fl), 0° (f2) and 90 ° right (f3) positions.
@
1. EXTENSION CORD - (Figure G) Always keep
extension cord behind trimmer and away from the
trimming operation. Never drape it over a hedge being
trimmed. If you cut or damage the cord, unplug it at the
electrical outlet immediately, before inspecting or
repairing cord.
2. WORKING POSITION - Maintain proper footing and
balance and do not overreach. Wear safety goggles,
non-skid footwear and rubber gloves when trimming.
Hold the toot firmly in both hands and turn the tool ON.
Always hold the trimmer, as shown in figure G, with
one hand on the switch handle and one hand on the
bait handle. Never hold the tool by the blade guard.
3. TRIMMING NEW GROWTH - (Figure H) - A wide,
sweeping motion, feeding the blade teeth through the
twigs is most effective. A slight downward tilt of the
blade, in the direction of motion gives the best cutting.
Z_ CAUTION: Do not use the trimmer for cutting stems
greater than 3/4 in. (19mm). Use the trimmer only for
cutting normal shrubbery found around houses and
buildings.