Advertisement
down so they are stored away neatly.
IMPORTANT: Always fully fasten the backrest
cover over the bumper bar. Never use with the
cover partially attached.
24•Lower the backrest into the lowest position, see
page 6
Lift the foot end of the pram upwards from the
seats backrest.
FITTING THE HOOD: Attach the hood to the frame
on the oposite side to the handles by pushing the
hood brackets into the armrest slots until they lock
in place.
25•Fasten the studs on the back of the hood to the
studs on the underside of the pushchair footrest.
ATTACHING THE APRON: Slot the apron over the
backrest of the pushchair.
Fasten the press studs on the sides of the apron to
the studs on the sides of the pushchair.
Reverse the procedure to convert back into a
pushchair.
SUREFIX SYSTEM
The swift, practical system that allows you to
fasten car seat to stroller (Primo Viaggio SIP 30 . 30
car seat sold separately).
26• SUREFIX HOOKS FOR THE STROLLER: to raise the
Surefix connectors on the chassis, pull the lever
outwards and at the same time swivel the two
connectors upwards until they click (fig_a).
To lower the stroller Surefix hooks, pull the lever
outwards while turning the hooks downwards
(fig_b).
27• Pliko Four + Primo Viaggio SIP 30•30: (capacity:
5-30 pounds and up to 30 inches))
to fasten the car seat to the stroller proceed as
follows:
- set the brakes on the stroller;
- lower the stroller backrest completely;
- raise the stroller Ganciomatic hooks;
- place the car seat so that it faces the mother and
press it down until it clicks into place;
- It is important not to remove the front bar from the
stroller when fastening the car seat (for fastening the
front bar, please see point 20);
- To remove the car seat from the stroller, please
refer to its instructions manual.
SERIAL NUMBERS
28•Behind the Pliko Four backrest information
relating to product name, date of manufacture and
serial number of the product are provided. This
information is required for any complaints.
CLEANING AND MAINTENANCE
PRODUCT MAINTENANCE: protect from the weather:
water, rain, or snow; prolonged and continuous
exposure to bright sunlight may give rise to colour
changes of various materials; store this product in a
dry place. The maintenance have to be regularly.
CLEANING THE CHASSIS: periodically clean all
plastic parts with a damp cloth. Do not use solvent
or similar cleaning products; keep all metal parts
dry to prevent rusting; keep moving parts clean
(adjustment mechanisms, locking mechanisms,
wheels, ...) and free of dust and sand and, if
necessary, lubricate with light machine oil.
CLEANING THE RAIN CANOPY: wash with a sponge and
soapy water; do not use detergents.
CLEANING FABRIC PARTS: brush fabric parts to
remove dust and wash by hand at a maximum
temperature of 30°C; do not wring; do not use
chlorine bleach, do not iron; do not dry clean; do not
apply solvent-based stain removers and do not dry
in a tumble dryer.
- 16 -
Advertisement
