Troubleshooting - Task Force ZE04 Manual

TROUBLESHOOTING

Problem Cause
Motor will not start GFCI needs to be reset.
On/Off switch is in the "OFF" (O) position.
Power cord is not plugged in.
Extension cord is too long.
Extension cord is not proper gauge.
Extension cord is damaged.
Electrical outlet does not supply
adequate power.
Unit does not reach Diameter of garden hose is too small.
Water supply is restricted.
Not enough inlet water supply.
Water inlet filter is clogged.
Pump is sucking air.
Output pressure Not enough inlet water supply.
varies high and low
Pump is sucking air.
Water inlet filter is clogged.
Discharge nozzle is obstructed.
No detergent. Detergent container is empty.
Detergent bottle or suction tube
not properly connected.
Detergent is too thick.
Filter on detergent suction tube
is clogged.
Damaged or clogged detergent
suction tube.
Discharge nozzle is obstructed.
14
Solution
Press RESET button on the GFCI.
Turn switch to the "ON" ( | ) position.
Plug in power cord.
Replace extension cord with one no
greater than 14AWG, 50ft.
Try a different outlet.
Replace with an inch or 5/8 inch
garden hose.
Check garden hose for kinks, leaks
and blockage.
Open water source full force.
Remove filter and rinse out in
warm water.
Check that hoses and fittings are air
tight. Turn "OFF" machine and purge
pump by squeezing trigger gun until a
steady flow of water emerges through
the nozzle.
Turn water on full force. Check garden
hose for kinks, leaks or blockage.
Check that hoses and fittings are air
tight. Turn "OFF" machine and purge
pump by squeezing trigger gun until a
steady flow of water emerges through
the nozzle.
Remove filter and rinse out in warm water.
Blow out or remove debris with a
fine needle.
Add more detergent.
Check connections.
Dilute detergent
Run warm water through filter
to remove debris.
Remove obstruction or replace
detergent suction tube.
Turn nozzle tip to low-pressure position.
Blow out or remove debris with a
fine needle.