Description (Fig. A) - Yonanas Petra User Manual

Congratulations!
You have purchased a Petra product. Our aim is
to provide quality products with a tasteful design
and at an affordable price. We hope that you will
enjoy this product for many years.

Description (fig. A)

Your 282700 Petra ice-cream maker has been
designed for making ice cream from frozen
fruits. The appliance is not suitable for making
ice cream from fresh fruits. The appliance is
suitable for indoor use only. The appliance is
suitable for domestic use only.
1. On/off switch
2. Motor unit
3. Blade cone
4. Feeding tube"
5. Pusher
6. Gasket
7. Bottom cover
8. Spout
Initial use
Preparation
• Clean the appliance. Refer to the section
"Cleaning and maintenance".
• Clean the accessories. Refer to the section
"Cleaning and maintenance".
Assembly (fig. A)
Before you proceed, we need you to pay
attention to the following notes:
- Before assembly or disassembly, switch off
the appliance, remove the mains plug from
the wall socket and wait until the appliance
has cooled down.
• Place the motor unit (2) on a stable and
flat surface.
• Place the bottom (10.8 cm) of the gasket
(6) into the bottom cover (7).
Note: Do not place the top (9.5 cm) of the
gasket (6) into the bottom cover (7).
• Place the blade cone (3) onto the gasket (6).
• Tighten the bottom cover (7) onto the
feeding tube (4).
• Place the feeding tube (4) onto the motor
unit (2).
• Lock the feeding tube (4) by turning it into
the direction of the lock symbol.
Use (fig. A)
Before you proceed, we need you to pay
attention to the following notes:
- Do not leave the appliance switched on
continuously for more than two minutes.
After two minutes, switch off the appliance
and allow it to cool down for one minute
before switching it on again. Allow the
appliance to cool down completely after
every three cycles of "two minutes on /
one minute off".
- Do not insert your hands into the feeding
tube to press frozen fruits. Always use the
pusher. Do not exert pressure on the pusher.
- If the appliance starts to vibrate strongly and
produce less ice cream, switch off the appliance
and subsequently clean the blade cone.
Before you proceed, we would like you to
focus your attention on the following notes:
- Only operate the appliance when a bowl
of a suitable size is placed under the spout.
- Regularly clean the blade cone when
processing larger quantities of fruit.
• Place the appliance on a stable and flat
surface.
• Assemble the appliance. Refer to the section
"Assembly".
• Remove the pusher (5) from the feeding
tube (4).
• Place a bowl of a suitable size under the
spout (8).
• To switch on the appliance, set the on/off
switch (1) to the 'I' position.
• Cut the frozen fruits into pieces that fit into
the feeding tube (4).
• Insert the pieces of frozen fruit into the
feeding tube (4). Use the pusher (5) to
press the pieces of frozen fruit through the
feeding tube (4).
• If necessary, clean the blade cone (3).
• To switch off the appliance, set the on/off
switch (1) to the 'O' position.
• Remove the mains plug from the wall socket.
• Allow the appliance to cool down completely.
4