Sennheiser EK 300 IEM Instruction Manual page 17

Setting the frequency bank and the channel – "Frequency Preset"
Menu
Frequency Preset
B.Ch: 1. 1
Call up "Frequency
Preset"
When setting up multi-channel systems, please observe the
following:
Only the factory-preset receiving frequencies within one
frequency bank ("1" to "20") are intermodulation-free. It is vital
to observe the notes on frequency selection on page 21.
Overview of the frequency banks and channels:
Frequency bank
"1" to "20"
"U1" to "U6"
Entering a name – "Name"
Menu
Name
L i c h a e l
Call up "Name"
Via the "Name" menu item, you can enter a freely selectable name (e.g. the
name of the performer) for the receiver. The name is displayed on the
"Frequency/Name" standard display (see page 10). The name can consist
of up to 8 characters such as:
• letters (without pronounciation marks),
• numbers from 0 to 9,
• special characters and spaces.
To enter a name, proceed as follows:
Press the UP/DOWN button
Press the
SET
or to store the complete entry.
Adjusting the balance – "Balance"
Menu
Balance
0
Call up "Balance"
You can adjust the balance in 31 steps. In Focus mode (see next section)
and when one of the standard displays is shown, you can also use the UP/
DOWN button
balance setting depends on the selected audio mode (see next section).
SET
Frequency Preset
B.Ch:
863.100MHz
Select the
frequency bank
and confirm
"Stored"
Channels
up to 16 per
frequency bank
up to 16 per
frequency bank
Name
L i c h a e l
Enter a character
and confirm
"Stored"
SET button to change to the next segment/character
SET
Balance
Select the desired
setting
"Stored"
/ to adjust the balance. The mode of operation of the
Adjusting settings via the operating menu
1. 1
Type
System bank:
frequencies are factory-preset
User bank:
frequencies are freely selectable
/ to select a character.
0
SET
Frequency Preset
B.Ch:
6. 3
824.500MHz
Select the channel;
store the setting
SET
Name
Michael
Enter a character;
store the setting
Balance
5
Store the setting
SET
15