Ftemperature Check; Gto Turn Off The Remote Start; Hshut-Down Input For Remote Starter; Idisabling The Remote Start System - Autopage RS-725LCD Operation Manual

F. TEMPERATURE CHECK (OPTIONAL)
If you installed the optional temperature sensor, you can
monitor, Through the LCD screen, the present indoor
temperature of the passenger compartment before cooling or
heating your vehicle.
Press the transmitter
( )
press button; the in-door temperature will be shown
on the LCD screen. This reading may be higher than actual
ambient temperature due to the greenhouse and is relative
only the inside vehicle temperature.
G. TO TURN OFF THE REMOTE START:
When the engine is running (by remote start), if you want to
stop it,
1. Press button once on the remote transmitter under
remote start mode.
2. Move the optional remote start enable toggle switch to OFF
position. (If installed)
3. Press the brake pedal
The vehicle will shut down and turn off the parking light to
indicate engine stopped.
H. SHUT-DOWN INPUT FOR REMOTE STARTER:
If any of the following conditions exist while the system is operating, the engine will
not start or will shut down immediately:
1. The hood is opened.
2. The brake pedal is pressed.
3. Engine is over-revved. {"Tachometer checking type" only}
4. The pre-programmed run time (5 /10 / 20 / 30 minutes) has elapsed.
5.
Press button once on the remote transmitter under remote start mode.
6. Move the optional remote start enable toggle switch to OFF position.
(If installed)
7. The vehicle refused to start running after {3} unsuccessful attempts.
I. DISABLING THE REMOTE START SYSTEM:
This feature allows your system's remote start unit to be temporarily disabled to
prevent the vehicle from being remote started accidentally. This feature is useful if the
vehicle is being serviced or stored in an enclosed area. To disable the remote start,
move the optional remote start enable toggle switch to the OFF position.
buttons first, within 3 seconds
(If installed)
21