FITTING THE METER (925 AND 932 MODELS ONLY)
If you have a 925 or 932 water softener you now need to
fit the meter.
Fig.
5
'0' RINGS
BLANKING PLUGS
Remove the blanking plugs from the back of the control
valve (fig. 5). Assemble the meter and inlet/outlet yoke
onto the valve, checking that the '0' rings are in place,
and secure with the clamps and screws provided (fig. 6).
Fig. 6
Gently connect the meter drive cable protruding from
the back of the control valve into the drive socket on top
of the meter. Only insert as far as indicated in fig. 6.
f.I