Configuring Lan Setup - NETGEAR DGN3500 User Manual

Configuring LAN Setup

The LAN Setup screen allows configuration of LAN IP services such as Dynamic Host
Configuration Protocol (DHCP) and Routing Information Protocol (RIP).
The wireless modem router is shipped preconfigured to use private IP addresses on the LAN
side and to act as a DHCP server. The wireless modem router's default LAN IP configuration
is:
• LAN IP address: 192.168.0.1
• Subnet mask: 255.255.255.0
These addresses are part of the designated private address range for use in private networks
and should be suitable for most applications. If your network has a requirement to use a
different IP addressing scheme, you can make those changes in the LAN Setup screen.
To configure LAN settings, log in to the wireless modem router, and under the Advanced
heading, select LAN Setup. The following screen displays:
Figure 38.
If you make changes you must click Apply in order for the changes to take effect.
Note:
If you change the LAN IP address of the wireless modem router
while connected through the browser, you will be disconnected. You
must then open a new connection to the new IP address and log in
again.
72 | Chapter 5: Advance d Configuration
N300 Wireless Gigabit ADSL2+ Mode m Router DGN3500 User Manual