Advertisement
TROUBLESHOOTING
PROBLEMS
No dial tone
Are all the plugs correctly connected.
Is the phone plugged into the telephone outlet.
Phone does not work
Are all cords connected properly?
Phone does not ring
Ringer Switch may be set to OFF?
Slide switch to the ON position.
Other party cannot hear
Ensure Handset cord is connected properly.
you
Display showing
With the phone disconnected from the telephone
erroneous figures
line, enter the SETUP menu by holding down both
OR
the ERASE and DOWN buttons for a few seconds.
Display is corrupt or does
After that, reset LCD contrast (see the SETUP
not work as intended
section)
You may also RESET the phone by uninstalling all
batteries and unplugging the AC adaptor. Wait for
5 minutes before reinstalling the batteries or
plugging the AC Adaptor. This will also clear all
memories.
The display is faded
With the phone disconnected from the telephone
(Numbers are hard to see)
line, enter the SETUP menu by holding down both
the ERASE and DOWN buttons for a few seconds
and then adjust the contrast to a higher level (see
the SETUP section)
Are the batteries correctly installed?
Are the batteries fresh? Change all 4 batteries.
Replace all 4 batteries at the same time.
Cannot store numbers into
No batteries are installed or batteries are weak
Memory
or installed incorrectly.
Caller ID does not work
Make sure the Caller ID service is active and that
the batteries are OK.
The Caller ID display is
Press either the UP or DOWN button to see if
Blank
"NO CALLS" appears. Check if batteries are
properly installed. Check if you have received
the first Caller ID record.
CHECK
9
LOCATION OF CONTROLS
Hook Switch
RECALL Time
Setting Switch
MEMO Button
STORE Button
Receiver
RECEIVER VOLUME
(NORMAL/HIGH)
REDIAL Button
RECALL R Button
MICROPHONE
Battery Compartment
Mains Adapter Socket
(dc 6V, 300mA)
Telephone Line Socket
Handset Socket
OFF/LO/HI Ringer
Switch
2
Advertisement
