Lamp Replacement Procedure - Optoma DS325 User Manual

The screws on the

lamp cover and the
lamp cannot be
removed.
The projector

cannot be turned
on if the lamp
cover has not been
placed back on the
projector.
Do not touch the

glass area of the
lamp. Hand oil can
cause the lamp to
shatter. Use a dry
cloth to clean the
lamp module if it
was accidentally
touched.

Lamp Replacement Procedure:

1. Switch off the power to the projector by pressing the " " button.
2. Allow the projector to cool down for at least 30 minutes.
3. Disconnect the power cord.
4. Unscrew the two screws on the cover. 1
5. Lift up and remove the cover. 2
6. Unscrew the two screws on the lamp module. 3
7. Lift up the lamp handle and remove the lamp module slowly and carefully. 4
To replace the lamp module, reverse the previous steps.
8. Turn on the projector and reset the lamp timer.
Lamp Reset: (i) Press "Menu"  (ii) Select "OPTIONS"  (iii) Select
3
"Lamp Settings"  (iv) Select "Lamp Reset"  (v) Select "Yes".
Appendices
1
2
4
47
English