Table of Contents
Advertisement
4
200P6 LCD
Go to cover page
Front View
To switch monitor's power On and Off
1
Power LED
2
To access OSD menu
3
To adjust the OSD
4
To adjust brightness of the display
5
6
To adjust the OSD
7
To adjust speaker volume
8
Automatically adjust the horizontal position,
vertical position, phase and clock setting
9
Signal input selection
Activate PIP (Picture in Picture) window (200P6I)
10
or adjust screen size (200P6E)
Rear View
Installation
1 CVBS video input (for video model 200P6I- only )
2 S-Video input (for video model 200P6I- only )
3 Earphone jack
4 VGA input
5 DVI-I input
6 Audio R/L input
7 PC audio input
8 AC power input
Accessory Pack
Item
Connecting to Your PC
Connect the power cord, DVI and audio cable to the back of the
monitor firmly. (Philips has pre-connected VGA cable for the first
installation.)
Notes:If you use an Apple Macintosh , you need to connect the
special Mac adapter to one end of the monitor signal cable.
Connect the cables to the back of your computer by following these
steps:
(a) Turn off your computer and unplug its power cord.
(b) Connect the VGA or DVI cable to the video connector.
(c) Connect the audio cable.
Description
Power cord
VGA signal cable
EDFU pack
PC audio cable (lime)
Mac adaptor (optional)
DVI-D cable
TM
Advertisement
Table of Contents
