Siemens VS 07G2212 Instructions For Use Manual page 17

Vs07 series
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 12
en
Figure
18
Open the dust compartment cover
(see figure 16).
Remove the motor protection filter in
the direction of the arrow.
Empty the motor protection filter by
tapping it.
If the motor protection filter is very
dirty, wash it out.
Leave the filter to dry for at least 24
hours.
After cleaning, insert the motor
protection filter in the machine and
close the dust compartment cover.
Replacing the micro-hygiene filter
The motor protection filter should be
changed when starting a new pack of
bags.
Figure
19*
Open the dust bag compartment lid
(see figure 16)
Unlock the filter holder by pushing the
locking tab in the direction of the
arrow.
Remove the foam and micro-hygiene
filter.
Place a new micro-hygiene filter and
the foam in the filter holder.
Insert the filter holder back into the
vacuum cleaner and click it into place.
Replacing the micro active carbon filter
If your vacuum cleaner is equipped with
a micro active carbon filter, this should
be replaced every six months.
Figure
20*
Open the dust bag compartment lid
(see Figure 16).
Release the filter holder by moving the
locking lever in the direction of the
arrow.
Remove the micro active-carbon filter.
* Depending on equipment
Downloaded From Vacuum-Manual.com Manuals
Insert the new micro-active carbon
filter.
Reinsert the filter holder and clip into
place.
Replacing the HEPA filter
If your vacuum cleaner is equipped with a
HEPA filter, this should be replaced once a
year.
Figure
21*
Open the dust bag compartment lid
(see figure 16)
Unlock the HEPA filter by pushing the
locking tab in the direction of the
arrow and remove it from the vacuum
cleaner.
(see figure 20)
Insert the new HEPA filter and click it
into place.
After vacuuming up fine dust particles,
shake out the motor protection filter to
clean it and replace the micro-hygiene
filter, activated carbon filter or HEPA
filter if necessary.
Care
Always switch the vacuum cleaner off and
disconnect the power cord from the mains
before cleaning the vacuum cleaner.
The vacuum cleaner and plastic
accessories can be cleaned with a
commercial plastic cleaner.
Do not use abrasive, glass or all-
!
purpose cleaners.
Never immerse the vacuum cleaner in
water.
The dust compartment can, if necessary,
be cleaned with a second vacuum cleaner
or simply wiped with a dry cloth or dusting
brush.
Subject to technical changes.
13

Advertisement

Table of Contents
loading

Table of Contents