Operation With Blades; Blade Selection - Echo SRM-266T Operator's Manual

OPERATION

Operation With Blades

Blade use DEMANDS specific Brush Cutter configuration. Operation without specified shield, barrier
bar or U-handle, and harness can result in serious personal injury. Follow installation instructions.
TO USE
THESE
BLADES
You
must
install
these
parts!
DO NOT INSTALL BLADES ON GT (CURVED SHAFT) MODEL TRIMMERS.
• Arbor Diameter of Upper Blade Plate must match arbor diameter of blades.
• New cotter pin required each time blade is installed.
• Brush cutters over 7.5 kg (16.5 lbs.) dry weight (weight w/o fuel) require a double shoulder harness.
Note: The Barrier Bar is used to restrict rearward movement of the unit. The Barrier Bar is NOT A HANDLE
and should not be gripped when using or carrying the unit.

Blade Selection

The type of Blade used MUST be matched to the type and size of material cut. An improper or dull
blade can cause serious personal injury. Blades MUST be sharp. Dull blades increase the chance of
kick-out and injury to yourself and bystanders.
Plastic/Nylon Grass/Weed Blades may be used where ever
the nylon line head is used. DO NOT use this blade for heavy
weeds or brush!
16
Pro Maxi-Cut
Grass/Weed
Blade
Support Handle, w/or
w/o Barrier Bar
Plastic Shield
Harness
Upper Plate &
Flat Washer
Hex Nut
New Cotter Pin
Rigid Plastic
Tri-Cut
Grass/Weed Blade
U-Handle or Support
Handle
w/Barrier Bar
Plastic Shield
Harness
Upper Plate
& Glide Cup
Hex Nut
New Cotter Pin
SRM-266T
Metal Blade
U-Handle or Support
Handle
w/Barrier Bar
Metal Shield
Harness
Upper/Lower
Blade Plates
Hex Nut
New Cotter Pin
X7502027204
© 10/2014 ECHO Inc.