Installation; Replacing The Lamp; Closing The Door - Zanussi zrg15800wa User Manual

Problem
The temperature in the appli-
ance is too low/too high.

Replacing the lamp

Disconnect the plug from the mains socket.
1. Remove the screw from the lamp cover.
2. Remove the lamp cover (refer to the
illustration).
3. Replace the used lamp with a new lamp of
the same power and specifically designed

Installation

WARNING!
Refer to Safety chapters.
Positioning
This appliance can be installed in a dry, well
ventilated indoor where the ambient
temperature corresponds to the climate class
indicated on the rating plate of the appliance:
Climate Ambient temperature
class
SN +10°C to + 32°C
www.zanussi.com
Possible cause
The temperature regulator is
not set correctly.
The door is not closed correct-
ly.
The food products' tempera-
ture is too high.
Many food products are stored
at the same time.
The door has been opened of-
ten.
for household appliances (the maximum
power is shown on the lamp cover).
4. Install the lamp cover.
5. Tighten the screw to the lamp cover.
6. Connect the plug to the mains socket.
7. Open the door.
Make sure that the light comes on.

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
Climate
class
N
ST
T
Solution
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products temper-
ature decrease to room tem-
perature before storage.
Store less food products at the
same time.
Open the door only if necessa-
ry.
Ambient temperature
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
23