Installation Of Close Clearances Shields - New Buck Corporation 85 Manual

Non-catalytic unit

Hide thumbs Also See for 85:

Table of Contents

MODEL 85 INSTALLATION OF CLOSE CLEARANCE SHIELDS

Loosen the three (3) phillips head screws that secure the front cover plates to the front sides of the

stove.

2. Take rear close clearance shield and center with back and flushing with the bottom of the

stove using the self-tapping screws provided.

2. Remove self-tapping screws from rear of stove. Align holes in side shield with holes in rear

shield and attach to stove. NOTE: The rear of the side shields must go over the lip of the

rear shield.

You must measure one inch (1") out from the side of the stove to the inside of the shield and main-

tain approximately one inch (1") clearance while securing the shield to the back of the stove with

the 10-16x1/2" self tapping screws provided.

4. Before tightening the screws, insert the front end (Lip) of the side shield under the front

cover plate on the front side of the stove. Use the same step to install side shield on the op-

posite side of the stove.

Tighten all screws.

6. Place pipe shield on the back of the rear shield and align the two (2) holes on the parts and

secure with the phillips head screws provided.

THREE (3) PHIL-

LIPS HEAD

SCREWS

(FRONT COVER

PLATES)

LIP

REAR SHIELD

NOTE: Use the figure above to install the Close Clearance Shields. Do not use page 23 in the Model 85 In-

stallation/Operation Owners Manual.

(Optional)

FOUR (4) 10-16X1/2" SELF

DRILLING SCREWS

SIDE SHIELDS

PIPE SHIELD

TWO (2) PILLIPS

HEAD SCREWS

Table of Contents