Replacing The Drive Belt; Cleaning The Dust Cover And The Turntable Body - Sony PS-HX500 Operating Instructions Manual

Replacing the Drive Belt

The drive belt will wear or may even break
over time. In such a case, replace it with a
new one.
To obtain a spare drive belt, contact your
dealer or the customer support website.
(See page 26.)
1
Turn off your turntable and the
connected audio device and unplug
the AC adaptor from the power
outlet.
2
Remove the rubber mat.
3
Unhook the drive belt from the
motor pulley.
4
Put your finger and thumb into the
platter's round holes to hold the
platter and remove the platter.
5
Turn the platter upside down and
remove the drive belt.
6
Wind a new drive belt around the
platter while keeping it untwisted.
Follow the steps in "Assembling the
Turntable" to finish assembly. (See page
9.)
Note
Spare drive belts do not have the red
indication ribbon attached.
Cleaning the Dust Cover
and the Turntable Body
Use a dry, soft cloth to clean the dust cover
and the turntable body.
When it is hard to wipe off the soil, use a
cloth moistened with a mild detergent
solution. Do not use any chemical solution,
such as alcohol, benzine, or paint thinner,
that damages the finish.
21