Razor powerrider 360 Owner's Manual page 10

REPAIR AND MAINTENANCE
Reassembly
1
Install the chain onto the front
wheel sprocket. Slip the wheel
axle into the fork slot and through
the wheel (note the sequence of
the hardware pictured to the right).
Push the chain tensioner down to
create slack in the chain. Hand
tightened the front axle locknuts.
4
Thread the brake cable through
the brake adjuster barrel, through
the large spring and into the small
hole in the side of the anchor bolt.
Position the cable in the original
location (as indicated by the slight
kink in the cable) and tighten
securely. Reattach the cable cap
to the end of the cable
2
Verify the chain is properly
installed on each sprocket and that
the tensioner is correctly positioned
at the bottom of the chain.
5
Replace the motor cover/chain
guard. Refer to steps 1 and 2.
Brake Housing
Nut
Anchor
Front Fork
Washer
Bolt
Brake Plate
3
Install the brake housing anchor
on the front and brake plate using the
bolt, washer and nut. Do not tighten.
9
Note: Front wheel hardware
sequence
11-7 11-6 11-5 11-4 11-2
11-3 11-1
Right Side (Throttle)
11-7 Axle Bolt
Fork
11-6 Spacer (long)
Left Side (Brake)
11-1 Locknut
11-2 Washer
Fork
11-3 Spacer (short)
11-4 Brake Plate
11-5 Spacer (short)