Limitations; Emergency Procedures / Abnormal Procedures - Cessna 1980 172RG Cutlass Pilot Operating Handbook

.6
CESSNA 300A AUTOPILOT
(TYPE AF-395A)
SECTION 2

LIMITATIONS

The following autopilot limitation must be followed during airplane
operation:
Autopilot must be OFF for takeoff and landing
1.
OPERATING LIMITATION WITH AUTOPILOT ENGAGED:
Maximum Airspeed -- 155 KIAS.
1.
SECTION 3
EMERGENCY PROCEDURES
TO OVERRIDE THE AUTOPILOT:
1. Airplane Control Wheel -- ROTATE as required to override auto -
pilot.
The servo may be overpowered at any time without dam-
age.
TO TURN OFF AUTOPILOT:
1. A/P ON-OFF Switch -- OFF.
SECTION 4
NORMAL PROCEDURES
BEFORE TAKE-OFF AND LANDING:
1. A/P ON-OFF Switch -- OFF.
2. BACK CRS Button -- OFF (see Caution note under Nav Intercept).
Periodically verify operation of amber warning light(s),
labeled BC on CDI(s), by engaging BACK CRS button with
a LOC frequency selected.
4
PILOT'S OPERATING HANDBOOK
SUPPLEMENT
NOTE
NOTE
1 July 1979
PILOT'S OPERATING HANDBOOK
SUPPLEMENT
INFLIGHT WINGS LEVELING:
1. Airplane Rudder Trim -- ADJUST for zero slip ("Ball" centered on
Turn Coordinator).
2. PULL-TURN Knob -- CENTER and PULL out.
3. A/P ON-OFF Switch -- ON.
4. Autopilot TRIM Control -- ADJUST for zero turn rate (wings level
indication on Turn Coordinator).
For optimum performance in airplanes equipped as float-
planes, use autopilot only in cruise flight or in approach
configuration with flaps down no more than 10° and
airspeed no lower than 75 KIAS on 172 and R172 Series
Models or 90 KIAS on 180, 185, U206 and TU206 Series
Models.
"COMMAND TURNS:
1.
PULL-TURN Knob -- CENTER, PULL out and ROTATE.
HEADING SELECT:
1. Directional Gyro -- SET to airplane magnetic heading.
2. Heading Selector Knob -- ROTATE bug to desired heading.
3. Heading Select Button -- PUSH.
4. PULL-TURN Knob -- CENTER and PUSH.
Airplane will turn automatically to selected heading. If
airplane fails to hold the precise heading, readjust autopi-
lot TRIM control as required or disengage autopilot and
reset manual rudder trim (if installed).
NAV INTERCEPT (VOR/LOC):
1. PULL-TURN Knob -- CENTER and PULL out.
2. NAV 1-2 Selector Switch -- SELECT desired receiver.
3. Nav Receiver OBS or ARC Knob -- SET desired VOR course (if
tracking omni).
Optional ARC knob should be in center position and ARC
warning light should be off.
LJuly 1979
CESSNA 300A AUTOPILOT
(TYPE AF-395A)
NOTE
NOTE
NOTE
.6
5