Mitsubishi Electric PL-KAK Operation Manual page 4

. Parts Names
n Wired Remote-Controller
Display Section
For purposes of this explanation,
all parts of the display are shown
as lit. During actual operation,
only the relevant items will be lit.
Identifies the current operation
Shows the operating mode, etc.
* Multilanguage display is support-
ed.
"Centrally Controlled" indicator
Indicates that operation of the re-
mote controller has been prohibited
by a master controller.
"Timer is Off" indicator
Indicates that the timer is off.
Temperature Setting
Shows the target temperature.
Operation Section
Set Temperature buttons
Down
Up
Timer Menu button
(Monitor/Set button)
Mode button (Return button)
Set Time buttons
Back
Ahead
Timer On/Off button
(Set Day button)
Opening the
door
Note:
"PLEASE WAIT" message
This message is displayed for approximately 3 minutes when power is supplied to the indoor unit or when the unit is recovering from a power
failure.
"NOT AVAILABLE" message
This message is displayed if a button is pressed to operate a function that the indoor unit does not have.
If a single remote controller is used to simultaneously operate multiple indoor units that are different models, this message will not be displayed
if any of the indoor units is equipped with the function.

Day-of-Week
Shows the current day of the week.
Time/Timer Display
Shows the current time, unless the simple or Auto
Off timer is set.
If the simple or Auto Off timer is set, shows the time
remaining.
Up/Down Air Direction indi-
cator
The indicator shows the direc-
tion of the outcoming airflow.
"One Hour Only" indicator
Displayed if the airflow is set to
Low and downward during COOL
or DRY mode. (Operation varies
according to model.)
The indicator goes off after one
hour when the airflow direction
also changes.
Room Temperature display
Shows the room temperature. The room
temperature display range is 8–39 °C.
The display blinks if the temperature is
less than 8 °C or 39 °C or more.
Louver display
Indicates the action of the swing louver.
Does not appear if the louver is station-
ary.
(Power On indicator)
Indicates that the power is on.
Built-in temperature sensor
"Sensor" indication
Displayed when the remote controller
sensor is used.
"Locked" indicator
Indicates that remote controller but-
tons have been locked.
"Clean The Filter" indicator
Comes on when it is time to clean the
filter.
Timer indicators
The indicator comes on if the corre-
sponding timer is set.
Fan Speed indicator
Shows the selected fan speed.
Ventilation indicator
Appears when the unit is running in
Ventilation mode.
ON/OFF button
Fan Speed button
Filter button
(<Enter> button)
Test Run button
Check button (Clear button)
Airflow Up/Down button
Louver button
( Operation button)
T o r e t u r n o p e r a t i o n
number.
Ventilation button
( Operation button)
To go to next operation
number.