Table of Contents
Advertisement
User instructions
Bass enhancement
1: To increase the bass level press the BASS (B)+ button
(25) repeatedly .
MUSIC
2: To decrease the bass level press the BASS (B)- button
(25) repeatedly .
NOTE: The BASS levels range from -4 to +4.
Mute function
1: Pressing the MUTE button (26) on the remote will
temporarily silence the audio output . You will see
'MUTE' flash on the display to indicate the mute
function is active .
MUSIC
2: Press the MUTE button again to resume the audio
output .
Sleep timer
The unit can be set to enter STANDBY mode after a
period of time.
1: During playback mode of either TV, COAX, OPTICAL or
AUX modes, press the SLEEP button (23) to enter the
timer settings .
2: Press the SLEEP button repeatedly to cycle through
the available time duration options of :- 5, 10, 15, 30,
45, 60, 90 minutes & OFF .
MUSIC
3: When you have selected the required timer duration,
just leave all buttons untouched for 2 seconds and
the timer will begin the countdown .
Sleep timer (cont)
4: When the timer elapses the STANDBY mode will be
activated .
BASS
Adjusting the display brightness
1: Press the DIM . button (24) repeatedly to cycle through
the 3 brightness states LOW, MED & HIGH .
Bluetooth operation
Pairing a Bluetooth device
Before you can use the sound bar with your phone or
other bluetooth capable device you will need to pair
the device to the sound bar.
1: Press the SOURCE button (5, 18) repeatedly until you
see 'BT' appear on the display .
BASS
2: When selected the 'BT' text on the display will flash
rapidly after 5 seconds while the unit tries to connect
to previously paired devices . If no devices are found
the 'BT' text will still flash but slowly to indicate it is
ready for pairing a new device .
3: Enable the Bluetooth function on your audio device
and search for a device labelled 'BUSH CBAR7W' in
the available list .
4: Select and enable pairing for the 'BUSH CBAR7W'
device . If prompted for a password enter '0000' .
5: If pairing is successful the CBAR7W will beep and the
'BT' text will stop flashing .
6: If the connected device goes out of range, the sound
bar will attempt to connect for 2 minutes . When the
device comes into range the sound bar will reconnect
again automatically .
7: To remove the paired device using only the sound bar,
press and hold the OPTION button (22) on the remote
BASS
control . The 'BT' text will begin flashing slowly again .
MUSIC
BASS
Page 7
Hide quick links:
Advertisement
Table of Contents
