Table of Contents
Advertisement
Connecting the Antenna for an Indoor Installation
Turn off your wireless unit.
1.
In the procedure
2.
have been assembled for indoor installation using a NETGEAR cable ACC-10314-01, 02, 03,
04 or 05 and the reverse N/SMA adaptor connected to the antenna. The provided 2m cable
should not have been used.
Figure 2-3: Antenna Assembly Installation Indoors
Locate the primary detachable antenna. Remove the antenna and connect the other end of the
3.
NETGEAR cable ACC-10314-01, 02, 03, 04 or 05 to this port.
NOTE: On access points with two antennas, if you are only replacing one antenna, be sure to
replace the primary antenna and do not remove the secondary antenna.
After attaching your new 9dBi antenna, reconnect your wireless device to the network and turn
4.
it on.
Installing the 9 dBi Omni-directional Antenna
Installation Guide for the 9 dBi Omni-directional Antenna ANT2409
"First, Assemble and Mount the Antenna" on page
2-2, the antenna should
2-5
Advertisement
Table of Contents
