The Front Panel Status Lights; The Rear Panel - NETGEAR RangeMax WPN802 Reference Manual

Reference Manual for the NETGEAR RangeMax™ Wireless Access Point WPN802

The Front Panel Status Lights

You can use the status lights on the front panel of the WPN802 to verify connections. The table
below describes the lights on the front panel.
Table 2-1. Status Light Descriptions
Label Activity
Power On Green Solid
Off
Test On
Off
WLAN On
Off
Ethernet On (Green)
Blink (Green)
On (Amber)
Blink (Amber)
Off

The Rear Panel

The rear panel of the WPN802 contains the items listed below.
Power
Figure 2-1: WPN802 Rear Panel
2-4
Description
Power is supplied and the
Power is not supplied to the
The unit is performing the power on self test diagnostic.
The unit successfully completed the power on self test diagnostic.
The Wireless port is initialized and the wireless feature is enabled.
The wireless feature is turned off or there is a problem.
The Ethernet port has detected link with a 100 Mbps device.
Data is being transmitted or received at 100 Mbps.
The Ethernet port has detected link with a 10 Mbps device.
Data is being transmitted or received at 10 Mbps.
No link is detected.
4
Ethernet Port Reset Button
202-10101-01, May 2005
WPN802
has passed its diagnostic test.
WPN802
.
Seven integrated
antennas inside
LEDs show which
antenna is on.
Introduction