Registering The Handset To The Base Unit - Panasonic KX-TGA659EX Installation Manual

TGA659EX(ex).book Page 5 Monday, August 23, 2010 4:14 PM
Battery installation/Battery charge
When the language selection is displayed after installing the batteries for the
first time, you can select your desired language.
{V}/{^}: Select your desired language. i M i {ic}
Important:
• Use the supplied rechargeable batteries. For replacement, we recommend
using the Panasonic rechargeable batteries noted in the base unit's operating
instructions.
• Wipe the battery ends (S, T) with a dry cloth.
• Avoid touching the battery ends (S, T) or the unit contacts.
• Confirm correct polarities (S, T).
• USE ONLY Ni-MH batteries AAA (R03) size.
• Do NOT use Alkaline/Manganese/Ni-Cd batteries.
Place the handset on the charger for about 7 hours before initial use.
Note:
• The handset display may show "Please wait for 1 minute." when the
handset is placed on the charger if it is not registered to the base unit.
• If the batteries are fully charged, but the operating time seems to be shorter,
clean the battery ends ( ,
S T
charge again.

Registering the handset to the base unit

Ensure that the handset is switched on. If it is not on, press and hold {ic} for
few seconds to turn the handset on.
1
Handset:
Lift the handset and press {ic}.
2
Base unit:
Press and hold {x} for about 5 seconds, until the registration tone sounds.
• If all registered handsets start ringing, press the same button to stop. Then
repeat this step.
(page 2: 2)
) and the charge contacts with a dry cloth and
5