Table of Contents
Advertisement
Quick Links
Thank you for purchasing a Panasonic product.
This unit is an additional handset compatible with the
following series of Panasonic Digital Cordless Phone:
KX-TG7301/KX-TG7321/KX-TG7341/KX-TG8301/
KX-TG8321/KX-TG6411/KX-TG6421/KX-TG6461/
KX-TG8411/KX-TG6481
You must register this handset with your base unit before it
can be used. This installation manual describes only the
steps needed to register and begin using the handset. Please
read the base unit's operating instructions for further details.
Charge the batteries for about 7 hours before initial use.
Please read this installation manual before using the unit and
save it for future reference.
Installation Manual
Additional Digital Cordless Handset
Model No.
KX-TGA648AZ
Advertisement
Table of Contents
Related Manuals for Panasonic KX-TGA648AZ
Summary of Contents for Panasonic KX-TGA648AZ
- Page 1 Installation Manual Additional Digital Cordless Handset KX-TGA648AZ Model No. Thank you for purchasing a Panasonic product. This unit is an additional handset compatible with the following series of Panasonic Digital Cordless Phone: KX-TG7301/KX-TG7321/KX-TG7341/KX-TG8301/ KX-TG8321/KX-TG6411/KX-TG6421/KX-TG6461/ KX-TG8411/KX-TG6481 You must register this handset with your base unit before it can be used.
-
Page 2: Accessory Information
Accessory information Supplied accessories Accessory item/Part number Quantity Charger AC adaptor/PQLV219AL Rechargeable batteries HHR-55AAAB or N4DHYYY00001 Handset cover Belt clip *1 Please read the base unit’s operating instructions for replacement battery information. *2 The handset cover comes attached to the handset. Note: L Please read the base unit’s operating instructions for additional/ replacement accessories. -
Page 3: Battery Installation/Battery Charge
(220-240 V AC, 50/60 Hz) Hooks Note: L Use only the supplied Panasonic AC adaptor PQLV219AL. L The AC adaptor must remain connected at all times. (It is normal for the adaptor to feel warm during use.) Battery installation/Battery charge Important: L Use the supplied rechargeable batteries. - Page 4 Charge for about 7 hours. L When the batteries are fully charged, the charge indicator goes off. Confirm “Charging” is displayed. Rechargeable Ni-MH ONLY Note: L When the language selection is displayed after installing the batteries for the first time, you can select your desired language. {V}/{^}: Select your desired language.
- Page 5 Controls A Speaker B Headset socket C {C} (Talk) D {s} (Speakerphone) E Dial keypad F {R/E} R: Recall/Flash E: Alarm shortcut key G Charge indicator Ringer indicator H Receiver I Display J {ic} (Off/Power) K {C/T} (Clear/Mute) L {INT} (Intercom) M Microphone N Charge contacts N Control type...
-
Page 6: Registering The Handset To The Base Unit
Registering the handset to the base unit Ensure that the handset is switched on. If it is not on, press and hold {ic} for few seconds to turn the handset on. Handset: Lift the handset and press {ic}. Base unit: Proceed with the operation for your model. -
Page 7: For Your Safety
For your safety To prevent severe injury and loss of life/property, read this section carefully before using the product to ensure proper and safe operation of your product. WARNING Power connection L Completely insert the AC adaptor/power plug into the power outlet. Failure to do so may cause electric shock and/or excessive heat resulting in a fire. -
Page 8: Other Information
L Exercise care when handling the batteries. Do not allow conductive materials such as rings, bracelets, or keys to touch the batteries, otherwise a short circuit may cause the batteries and/or the conductive material to overheat and cause burns. L Charge the batteries provided with or identified for use with this product only, in accordance with the instructions and limitations specified in this manual. - Page 9 L Since water in headset socket may cause damage, close the headset socket cover when the optional headset is not in use. When the optional headset is connected, do not use the handset with wet hands. L If the handset is wet, wipe with a soft dry cloth. L The base unit/charger is not designed to be splash resistant.
- Page 10 This material is copyrighted by Panasonic Communications Co., Ltd., and may be reproduced for internal use only. All other reproduction, in whole or in part, is prohibited without the written consent of Panasonic Communications Co., Ltd. © Panasonic Communications Co., Ltd. 2009...