Fender Musical Instruments Co. All specifications subject to change without notice. For warranty repair service, only Fender specified part numbers are to be used. It is recommended they also be used for post-warranty maintenance and repair.
BXR 200 CIRCUIT DESCRIPTION PREAMP J1 is a high sensitivity input which can be driven with as much as 2.5 volts RMS. J2 is a low sensitivity input which is recommended for Bass Guitars with active pickups, and can handle as much as 5 volts RMS.
Page 5
BXR 200 DELTACOMP (Cont) The attack and release circuit for the DeltaComp is made up by the Diode, Resistor, and Capacitor network which drives the Base of Q19. Comparator U1A senses the voltage from the Collectors of Q20 & Q21.
BXR 200 Transistors Q11, Q12, and associated components comprise the Current Limiting or Short Proof protection circuit. There are usually two conditions which demand excessive output current from the amplifier. A shorted speaker cable, or a load impedance which is below the minimum rating of the amplifier. If these conditions occur, the voltage drops across the Emitter Resistors (.33Ω...
Page 7
LED 5X5MM YELLOW SLB-55YY3 028039000 LED RED 5X5MM SLB-55VR3 LD1,3 048947001 PCB ASSY PREAMP BXR 200 STUFFED 048946000 PCB FAB PRE AMP BXR 200 RAW PCB 025818001 RES CF 1/4W 5% 4.7 OHM LL 024974001 RES CF 1/4W 5% 47OHM LL...
Page 8
IC REGULATOR –15V MC 7915CT 027387000 INDUCTOR AIR CORE RDL 2.5UH 038815000 INSULATOR SILICONE TO-3P @Q15-18 026043000 JUMPER WIRE 18GA .8X.175 JP1,2 020888001 JUMPER WIRE 22GA W1-27 048843001 PCB ASSY PWR AMP BXR 200 STUFFED 048842000 PCB FAB PWR AMP BXR 200 RAW PCB...