WLtoys V222 Instruction Manual page 4

- Using the gear lever you can control the rotation axis of the drone. Using the directional lever you can control the flight direction
of the copter.
- Swap the layout of the throttle between the right and the left by switching the lever on as number 9
- To switch mode's from 2 to 4 or 1 to 3 or vice-versa: 1. Turn off remote. 2. Keep model button pressed 3. Turning on the
controller.
- The different calibration buttons help keep the copter stationary. Test this by pressing the accelerator and calibration buttons to
maintain the copter in one place.
- You can choose the percentage of the speed. The higher the value, the faster the reaction will be (e.g. 100% will be more
responsive than 40%). (helicopter L<H).
- The two buttons on the top and the button on the bottom right are used to activate different modules : photos / shots / basket.
How to fly
Flying is really simple, but you need a little practice at first. Connect to www.wltoys.eu to watch educational films.
Copyright WLtoys.eu | DroneX BV
1. Power LED
2. 4 speeds control
3. Gear lever
4. Throttle trim
5. Rotation trim
6. LCD display
7. Antenna
8. Power switch
9. Mode 1 or 3 / Mode 2 or 4 switch (hardware)
10. 360 degree Roll
11. Directional lever
12. Forwards and backwards trim
13. Crab trim
14. Module 1 : Water jet; bubble jet; video; basket up; lead
single missile
15. Lighting control
16. Module 2 : Taking photos, running missiles, basket down
17. Mode 1 or 3 / Mode 2 or 4 switch (software)
Insert the battery by sliding the cover down. Then insert 4 x AA
batteries as indicated under the cover.