WLtoys V222 Instruction Manual page 8

Wltoys
Copyright WLtoys.eu | DroneX BV
This model can be equipped with different modules. This is
available from your retailer or on www.wltoys.eu.
A module may be included in some models.
1. Camera
2. Bubble
3. Fountain
4. Bullet
5. Rescue
The modules are installed as follows:
1. Remove the module from its packaging and place the V-
shaped feet in stirrups at the bottom of the fuselage of the
drone. Make sure the right side is facing forward.
2. Push until a click is heard. If you do not hear a click, rotate
180 degrees and try again.
3. Then connect the plug to the matching slot provided for that
purpose on the support base.
The various modules installation procedure is the same. Keep in
mind that modules must be connected to the base
corresponding to the support base. In the illustration you will find
the exact location of these bases.
1. CAMERA = camera
2-3. SPRAYER = fountain or bubble blower
4. MISSILE = missile shooter
5. HOIST = Rescue module
NB: On www.wltoys.eu you will find the educational films where
everything is explained step-by-step with images and sound.
Imported by: WLtoys.eu / DroneX BV
Bloemstraat 86HS 1016 LE Amsterdam | www.wltoys.eu |
info@wltoys.eu
Our products comply with the standards and criteria of the
European Union and approved by the EC. For your safety, we
recommend that you read the entire manual before your first
flight.