Panasonic UB-5838C Service Manual page 33

Error Code
Display Code Name
U103024 Dark Data Error
U103025 White Data Error
U306001 Un-supported SD
U306002 Memory Card
U306010 Unavailable
space in SD
Memory Card
U306014 Folder on SD
Memory Card
Read Only
U306035 SD Memory Card
Write-protection
U306144 SD Memory Card
Write Error
U306160 Same as "U306014"
U307001 Un-supported
U307002 USB Flash
Memory Device
U307010 Unavailable
space in USB
Flash Memory
Device
U307014 Folder on USB
Flash Memory
Device Read Only
Possible Cause
1. Dark data level is not proper
as the scanned data.
2. CIS is damaged.
1. CIS signal is saturated due
to incoming light or sunlight
to the CIS.
2. CIS is damaged.
3. Lens is dirty.
1. SDHC Memory Card is set
to this unit.
1. Unusable SD Memory Card
is set to this unit.
2. SD Memory Card is not
proper format for this
unit.
In the SD Memory Card, there
is not enough storage space
available.
The following folders in the SD
Memory Card are set to "Read
Only".
(1) For UB-5838C
Folder Name: "UB-5838C"
(2) For UB-5338C
Folder Name: "UB-5338C"
The SD Memory Card has
been set to write-protection.
During scanning, SD Memory
Card Write Error occurred.
1. Unusable USB Flash
Memory Device is set to
this unit.
In the USB Flash Memory
Device, there is not enough
storage space available.
The following folders in the
USB Flash Memory Device
are set to "Read Only".
(1) For UB-5838C
Folder Name: "UB-5838C"
(2) For UB-5338C
Folder Name: "UB-5338C"
1. Check that the screen surface for shading is not dirty.
2. Check the connection between CN606 (SCANNER Board)
and CN5 (CONTROL Board).
3. Check the connection between CN4 (CONTROL Board)
and CN800 (MOTOR DRIVE Board).
4. Check the connection between CN604 (SCANNER Board)
and CN801 (MOTOR DRIVE Board).
5. Check the connection between CN605 (SCANNER Board)
and Scanner Assy.
6. Check the connections between CIS and CN600 to CN603
(SCANNER Board).
7. Check the soldering conditions of the following parts on the
SCANNER Board.
→ IC600, IC602 to IC610, IC614, and Q601 to Q606
8. Check the soldering conditions of the following parts on the
CONTROL Board.
→ IC6 to IC10
9. Replace faulty parts, Scanner Assy., SCANNER Board,
CONTROL Board, or CIS.
1. Check that the screen surface for shading is not dirty.
2. Wipe off the dirt on the lens surface.
3. Replace faulty parts or Scanner Assy.
Must not use a SDHC Memory Card.
Format to comply with SD memory card specifications using
the formatting software that can be downloaded from the
following site.
http://panasonic.jp/support/global/cs/sd/download/
sd_formatter.html
1. Make space available with a PC.
1. Change the folder property to "Read / Write".
1. Cancel the write-protection.
1. Check whether the SD memory card is normally written
with a PC.
1. Replace the USB Flash Memory Device so that the device
meets the requirements of this unit.
1. Make space available with a PC.
1. Change the folder property to "Read / Write".
33
Check Point