Motorola vap2400 Installation Manual page 16

Troubleshooting
Rapidly blinking WPS LED
Cannot configure a VAP unit as an
Access Point
VAP2400 Wireless Video Bridge • Installation Manual
If the LED remains in this state for longer than two minutes, go to the unit's back panel
and push the WPS button. The LED may continue flashing in a different pattern, rapidly
blinking for 1 second and then resting briefly before blinking again. If this occurs, wait
one to two minutes and then press the WPS button again.
If you cannot establish one of your units as an Access Point, it may indicate that your
router is not connected to your service provider's network. (The
lights green on VAP units dedicated as Access Points and amber on VAP units dedicated
as Clients; see pp. 9–11 for more details.) If you experience this problem, contact your
service provider for assistance.
operational mode LED
16