Brother MFC-J615W Basic User's Manual page 68

Error Message
BT Call Sign On
(U.K. only)
Cannot Detect
Cannot Print
Replace Ink
Comm.Error
Connection Fail
Cover is Open
Data Remaining
Disconnected
Document Jam
High Temperature
Hub is Unusable.
60
Cause
BT Call Sign is set to ON. You cannot
change the Receive Mode from
Manual to another mode.
You installed a new ink cartridge too
quickly and the machine did not detect
it.
If you are using non Brother Original
ink the machine may not detect the ink
cartridge.
An ink cartridge is not installed
correctly.
One or more of the ink cartridges have
reached the end of their life. The
machine will stop all print operations.
While memory is available,
monochrome faxes will be stored in
the memory. If a sending machine has
a colour fax, the machine's
"handshake" will ask that the fax be
sent as monochrome.
Poor telephone line quality caused a
communication error.
You tried to poll a fax machine that is
not in Polled Waiting mode.
The scanner cover is not completely
closed.
The ink cartridge cover is not
completely closed.
Print data is left in the machine's
memory.
The other person or other person's fax
machine stopped the call.
The document was not inserted or fed
correctly, or the document scanned
from the ADF was too long.
The print head is too warm.
A Hub or USB Flash memory drive
with Hub has been connected to the
USB direct interface.
Action
Set BT Call Sign to OFF. (See BT Call
Sign (U.K. only) in chapter 5 in the
Advanced User's Guide.)
Take out the new ink cartridge and
re-install it slowly until it clicks.
Replace the cartridge with a Brother
Original ink cartridge. If the error
message remains, contact your
Brother dealer.
Take out the new ink cartridge and
-
re install it slowly until it clicks. (See
Replacing the ink cartridges
on page 53.)
Replace the ink cartridges. (See
Replacing the ink cartridges
on page 53.)
If the problem continues, call the
telephone company and ask them to
check your telephone line.
Check the other fax machine's polling
setup.
Lift the scanner cover and then close it
again.
Firmly close the ink cartridge cover
until it clicks.
Press Stop/Exit. The machine will
cancel the job and clear it from the
memory. Try to print again.
Try to send or receive again.
(See Using the ADF on page 22.)
(See Document jam on page 66.)
Allow the machine to cool down.
A Hub or USB Flash memory drive
with Hub are not supported. Unplug
the device from the USB direct
interface.