Vpn Tunnel Control; Activating A Vpn Tunnel; Using The Vpn Status Page To Activate A Vpn Tunnel - NETGEAR DG834 ADSL Firewall Router DG834 DG834 Reference Manual

Figure 7-29: Current VPN Tunnels (SAs) Screen
Look at the VPN Status/Log screen
c.

VPN Tunnel Control

Activating a VPN Tunnel

There are three ways to activate a VPN tunnel:
• Use the VPN Status page.
• Activate the VPN tunnel by pinging the remote endpoint.
• Start using the VPN tunnel.
Note: Refer to "Using Auto Policy to Configure VPN Tunnels" on page 7-36
keepalive capability on an existing VPN tunnel.

Using the VPN Status Page to Activate a VPN Tunnel

To use the VPN Status screen to activate a VPN tunnel, perform the following steps:
Log in to the Router.
1.
Open the DG834 management interface and click on VPN Status to get the VPN Status/Log
2.
screen (Figure 7-30).
Virtual Private Networking (Advanced Feature)
Reference Manual for the ADSL Firewall Router DG834
(Figure 7-28) to verify that the tunnel is connected.
202-10005-05, June 2005
to enable the IKE
7-27