Memory Setting For 2Nd Stage; Memory Pad Heating - Panasonic ne-1037 BTQ Service Manual

OPERATION
4. The pad number and Stage
Heating Indicator will appear in
the display again.
5. Press Power Level pad 2
times.
(Sets to MED power)
6. Press 3 , 0 pads.
(Sets to 30 seconds)
7. Press Prog pad again.
8. 2 seconds later, the time and
power level setting for single
stage will appear in the display.
9. 2 seconds later, Double
Quantity Heating Indicator and
then the double heating time
will appear in the display.
10. 2 seconds later, the display will
go blank.
2.4.

Memory setting for 2nd stage

OPERATION
1. Follow steps 1 to 6 for memory
setting for single stage.
(MED power, 30 seconds for 1st
stage)
2. Press Power Level pad 3
times.
(Sets defrost power for 2nd
stage)
3. Press 2 , 0 , 0 pad.
4. Press Prog pad.
DISPLAY
5. 2 seconds later, the display
shows your setting program.
6. This indicates double cooking
time.
Example:
This means:
If you press "5", oven will
operate 30 sec-MED, 2 min-
DEF.
If you press "X2" and "5" oven
will operate 1 min-MED, 4 min-
DEF.
7. After all of your programming
has been completed, the
display will go blank.
2.5.
1. Plug the power supply cord into
wall receptacle.
2. Open the door.
Place a water load in the oven
and close the door.
DISPLAY
3. Press 7 pad.
(Sets for 2 minutes)
4. Press Start
5. When
elapsed, oven beeps 5 times
and shuts off. Display blinks
zero.
6. Open the door and take out
water
blinking.
7
OPERATION

Memory Pad Heating

OPERATION
pad.
cooking time has
load. Display stops
NE-1027 / NE-1037
DISPLAY
DISPLAY