Washing Clothes Manually; Using Delay Start - Samsung WD-J1255(V/S/C/R) Owners Informations

Washing a Load of Laundry

Washing clothes manually

You can wash clothes manually without using the Fuzzy Logic feature.
To do so:
1. Turn the water supply on.
2. Press the
(On/Off) button on the washing machine.
3. Open the door.
4. Load the articles one at a time loosely into the drum, without overfilling.
5. Close the door.
6. Put the detergent and, if necessary, softener or prewash detergent, in the appropriate
compartments.
7. Press the Temperature button to select the temperature.
(cold water, 30˚C, 40˚C, 60˚C, 95˚C)
8. Press to rinse button to select the required number of rinse cycles.
Maximum number of rinse cycles is five.
The washing duration will be prolonged accordingly.
9. Press the Spin button to select the spin speed. [
minute(rpm)]
Notice:
The rinse hold program allows you to take clothes that are dripping wet out of the
washing machine.
: No Spin
10. Press the button repeatedly to cycle through the available delayed start options (from 3 hour to 24
hours in one hour increments). Displayed hours means the time of finished washing-cycle.
11. Press the Start/Pause button and the machine will begin the cycle.

Using delay start

You can set the washing machine to finish your wash automatically at a later time, choosing from 3 to 24
hour delay (in 1 hour increments). Displayed hours means the time of finished washing-cycle.
To do this:
1. Manually or automatically set your washing machine for the type of clothes you are washing.
2. Press the Delay Start button repeatedly until the delay time is set.
3. Press the Start/Pause button. The Delay Start indicator will light, and the clock will begin counting
down until it reaches your finish time.
4. To cancel Delay Start, press the
B-5 SAMSUNG Washing Machine Owner's Instructions
, , 400, 800, 1000, 1200 , ... revolutions per
: Rinse Hold
(On/Off) button, then turn the washing machine on again.