Installation; Zero Configuration Setup - D-Link DCS-2310L User Manual

Hd poe outdoor cloud camera

Hide thumbs Also See for DCS-2310L:

Table of Contents

Section 2: Installation

Installation

If you have a mydlink-enabled Cloud Router, you can take advantage of Zero Configuration. Zero Configuration automatically

configures your camera's settings for you, and adds it to your mydlink account automatically. This type of setup allows you to

set up your camera by simply plugging it in and connecting it to your router.

Connect your camera to your mydlink-enabled Cloud Router and Zero Configuration will automatically configure your DCS-2310L

and automatically add the camera to your mydlink account. After the short time it takes to do this you can remotely access

your camera from the www.mydlink.com website to manage and monitor your DCS-2310L.

Attach the External Power Supply

Attach the external power supply to your wall outlet or power strip. Please skip

this step if your camera is connected using PoE (Power over Ethernet).

Note: If you choose to take advantage of the Power over Ethernet feature you may

unplug the power cable. However, to avoid water ingress ensure the provided

rubber weatherproof plug is used to fill the gap. See "Removing the Power Cable"

on page 11 for further instructions.

Connect the Ethernet Cable

Using the pre-attached Ethernet cable connect the free end to your network.

Note: To avoid damage to the weatherproof aspects of the camera, users are

advised not to remove the rear cable connection covering. To use a longer

ethernet cable or power cord install a coupling adaptor, or power extension strip.

D-Link DCS-2310L User Manual

Table of Contents

Show Quick Links

Table of Contents