Connecting To An Access Point In Infrastructure Mode; How To Configure An Infrastructure Mode Profile - NETGEAR WG111U User Manual

User's Manual for the NETGEAR Super AG Wireless USB 2.0 Adapter WG111U
For example, if you use your notebook PC to connect to a wireless network in an office and a
wireless network in your home, you can create a profile for each wireless network. Then, you can
easily load the profile that has all the configuration settings you need to join the network you are
using at the time.
There are two types of wireless network connections you can configure:
• Infrastructure Mode — uses the 802.11 infrastructure mode.
• Ad-hoc Mode — uses the 802.11 ad-hoc mode.
For more information on 802.11 wireless network modes, see
on page B-1 of this manual.

Connecting to an Access Point in Infrastructure Mode

This section provides instructions for configuring the NETGEAR Super AG Wireless USB 2.0
Adapter WG111U to connect to a wireless access point.

How to Configure an Infrastructure Mode Profile

Follow the instructions below to configure an infrastructure mode profile for connecting to an
access point.
1. Run the WG111U Smart Wireless Wizard.
Make sure the WG111U software is installed and the WG111U is connected to your PC.
a.
Open the configuration utility by clicking on the WG111U icon in the Windows system
b.
tray. The Settings page appears, as shown below.
4-2
"Wireless Networking Overview"
202-10065-01
Configuration